HTR Metal Tube Rotameter
Metal tube rotameter is the most commonly used rotameter in industry and laboratories. It is not only suitable for small flow measurement with pipe diameter D<150mm, but also can measure the flow of corrosive medium. But it must be installed in a vertical pipe section, and the fluid medium passes through the rotameter from bottom to top.
Description
Metal tube rotameter is the most commonly used rotameter in industry and laboratories. It is not only suitable for small flow measurement with pipe diameter D<150mm, but also can measure the flow of corrosive medium. But it must be installed in a vertical pipe section, and the fluid medium passes through the rotameter from bottom to top.
●Chemical plant
●Laboratory
●Liquefied Gas Station
●Natural Gas Transmission Center
●Boiler plant
Advantages
- Suitable for flow measurement of medium with small diameter and low velocity, simple structure, low pressure loss
- Wide flow ratio 10:1; double-line large liquid crystal display, optional on-site instantaneous or cumulative flow display.
- Non-contact magnetic coupling transmission, suitable for high temperature and high pressure and strong corrosive medium.
- Equipped with data recovery, data backup and power failure protection functions.
Resources
Technical Data
| Parameter | Specification |
| Caliber of flow meter | DN15，DN25，DN50，DN80，DN100，DN150 (Others on request） |
| Range of flow | Liquid:1.0～150000l/h
Gas:0.05～3000m3/h |
| Measure Ratio | 10:1，20:1（special） |
| Medium temperature | Standard:-30℃～+120℃,high temperature:120℃～350℃ |
| Environmental temperature | Local type:-40℃～120℃
Remote-control type:-30℃～60℃ |
| Storage requirement | Temperature: -40℃～85℃ humidity:≤85% |
| Output load | 500Ω（24V power supply） |
| Output signal | 4～20mADC (two-wire configuration);
attached HART Protocol allowed |
| Pressure rating | DN15,DN25,DN50:4.0MPa (Max: 20MPa） DN80,DN100,DN150:1.6MPa (DN80:Max 10MPa; DN100:Max 6.4MPa; DN150:Max 4.0MPa） |
| Power supply | 24VDC（12～36VDC） |
| Precision | Grade 0.5, Grade 1.0 (special) |
| Connection mode | Flange (Others on requests） |
| Cable interface | M20×1.5 |
| Housing protection grade | IP65 |
| Explosion-proof
|
Intrinsic safety type:ExiaIICT6，
Explosion-proof type:ExdIICT6 |
| Viscosity of medium | DN15:η＜5mPa.s
DN25:η＜250mPa.s DN50～DN150:η＜300mPa.s |
Downloads
Related products
Leave a Reply